摘要The disorderly emission and poor treatment effect of asphalt mixture fume in asphalt mixing stations have caused huge harm to the natural environment and human health. Based on the gravimetric method, self-designed and assembled fume generation-enrichment device that was suitable for the mixing state of asphalt mixture in the plant, and conducts research on the fume release rules during asphalt mixture mixing. Four kinds of petroleum asphalt were selected to consider the conditions of asphalt fume generation in the field mixing station. The mixing temperature, aggregate specific surface area and mixing frequency were determined as the key factors affecting the release of fume. The exposed area of the aggregate was calculated by the measured modified specific surface area calculation method, and the influence of each key factor on the smoke release of the plant-mixed asphalt mixture was analyzed. The results show that the self-designed and assembled fume generation-enrichment device has good stability and can ensure the accuracy of the experimental results. The magnitude of the light components in the fume under different mixing conditions is much lower than that of the heavy components, and the fume release after the base asphalt is modified by SBS is reduced. Mixing temperature is the most critical factor that determines the amount of fume release. The amount of fume release shows an obvious growth trend with the increase in temperature. Fume production has strong temperature sensitivity, and release varies significantly under different mixing temperatures. 160 ℃ and 170 ℃ are the jumping nodes of fume release. The amount of fume produced by the asphalt mixture is directly proportional to the specific surface area of the aggregate. The specific surface area of the aggregate directly affects the amount of fume released by determining the exposed area of the asphalt. The amount of fume release is positively related to the mixing frequency. Compared with the heavy components of the fume, the release amount of the light components of the fume is less affected by the mixing frequency. The research results can provide theoretical and technical support for the release and disposal of fume in mixing plants.
Abstract：The disorderly emission and poor treatment effect of asphalt mixture fume in asphalt mixing stations have caused huge harm to the natural environment and human health. Based on the gravimetric method, self-designed and assembled fume generation-enrichment device that was suitable for the mixing state of asphalt mixture in the plant, and conducts research on the fume release rules during asphalt mixture mixing. Four kinds of petroleum asphalt were selected to consider the conditions of asphalt fume generation in the field mixing station. The mixing temperature, aggregate specific surface area and mixing frequency were determined as the key factors affecting the release of fume. The exposed area of the aggregate was calculated by the measured modified specific surface area calculation method, and the influence of each key factor on the smoke release of the plant-mixed asphalt mixture was analyzed. The results show that the self-designed and assembled fume generation-enrichment device has good stability and can ensure the accuracy of the experimental results. The magnitude of the light components in the fume under different mixing conditions is much lower than that of the heavy components, and the fume release after the base asphalt is modified by SBS is reduced. Mixing temperature is the most critical factor that determines the amount of fume release. The amount of fume release shows an obvious growth trend with the increase in temperature. Fume production has strong temperature sensitivity, and release varies significantly under different mixing temperatures. 160 ℃ and 170 ℃ are the jumping nodes of fume release. The amount of fume produced by the asphalt mixture is directly proportional to the specific surface area of the aggregate. The specific surface area of the aggregate directly affects the amount of fume released by determining the exposed area of the asphalt. The amount of fume release is positively related to the mixing frequency. Compared with the heavy components of the fume, the release amount of the light components of the fume is less affected by the mixing frequency. The research results can provide theoretical and technical support for the release and disposal of fume in mixing plants.
基金资助:This work was financial supported by the National Natural Science Foundation of China (No.52368066),Natural Science Foundation of Gansu Province,China (No.23JRRA773),Gansu Provincial University Innovation Fund Project (No.2022A-026),and Lanzhou University of Technology Hongliu Outstanding Young Talent Program,China (No.04-062005).
通讯作者:
NIAN Teng-fei
引用本文:
NIAN Teng-fei, SONG Jia-qi, LI Jing-gao, LI Ping, CHEN Xiu-le. Analysis of Fume Enrichment Methods and Release Patterns of Plant-Mixed Asphalt Mixtures[J]. Journal of Highway and Transportation Research and Development, 2024, 18(2): 1-13.
NIAN Teng-fei, SONG Jia-qi, LI Jing-gao, LI Ping, CHEN Xiu-le. Analysis of Fume Enrichment Methods and Release Patterns of Plant-Mixed Asphalt Mixtures. Journal of Highway and Transportation Research and Development, 2024, 18(2): 1-13.
[1] YU M, WU S P, CHEN M Z, et al. Evaluation of Volatile Organic Compounds from Asphalt Using Uv-visible Spectrometer[J]. Advanced Materials Research, 2012, 472:432-436. [2] WANG Hu-ping. Experimental Study of Injury to the Liver and Kidney Tissue by Petroleum Bitumen Fume[D]. Lanzhou:Lanzhou University, 2007.(in Chinese) [3] LI Z T, WU Y J, ZHAO Y, et al. Analysis of Coal Tar Pitch and Smoke Extract Components and Their Cytotoxicity on Human Bronchial Epithelial Cells[J]. Journal of Hazardous Materials, 2011, 186(2/3):1277-1282. [4] ZANETTI M C, SANTAGATA E, FIORE S, et al. Evaluation of Potential Gaseous Emissions of Asphalt Rubber Bituminous Mixtures. Proposal of a New Laboratory Test Procedure[J]. Construction and Building Materials, 2016, 113:870-879. [5] LU Qing-bing, NI Wen-quan, LU Qing-qing, et al. Research on Green&Sustainable Development of Asphalt Pavement Under "Carbon Neutrality and Carbon Peaking" [J]. Journal of Municipal Technology, 2023, 41(5):42-51.(in Chinese) [6] NEGHAB M, DERISI F Z, HASSANZADEH J, et al. Toxic Responses of Different Organs Following Occupational Exposure to Sub-Threshold Limit Value Levels of Paving Asphalt Fumes[J]. Toxicological and Environmental Chemistry, 2017, 99(2):331-339. [7] BENGT J, GORAN N, BENKT H, et al. Exposure to Polycyclic Aromatic Hydrocarbons and Genotoxic Effects on Nonsmoking Swedish Road Pavement Workers[J]. Scandinavian Journal of Work Environment and Health, 1999, 25(2):131-136. [8] XU Yong-li, YANG Song-han, ZHOU Ji-sen, et al. Research on Influencing Factors of Asphalt Fume Release based on Quality Method[J]. Forest Engineering, 2022, 38(2):119-132.(in Chinese) [9] HUANG Gang, HE Zhao-yi, HUANG Tao. Laboratory Measurement and Analysis of Effect Factor on Asphalt Fume Under the Elevated Temperature[J]. Journal of Building Materials, 2015, 18(2):322-327.(in Chinese) [10] LI P, WANG M, NIAN T F, et al. Asphalt Fume Generation-Enrichment Device Development and Fume Production Estimation Model[J]. Advances in Civil Engineering Materials, 2021, 10(1):453-467. [11] LI Jing-ruo, LIU Rui-quan, TANG Bo-ming, et al. Improvement Effect of Polyester Fiber on TSR of MSWI Fly Ash/Asphalt Mixture[J]. Journal of Highway and Transportation Research and Development, 2022, 39(1):17-23,39.(in Chinese) [12] PARANHOS R, BEGHIN A, PETITEAU C, et al. Laboratory Characterization of Hot Mix Asphalt Fumes During Mixing Linked with Mechanical Performances[C]//Proceedings of 10th International Conference on Asphalt Pavements. Quebec:Transportation Association of Canada (TAC), 2006:397-406. [13] LIU Xing-dong, ZHANG Liang. Pavement Performance of Directly-injected PE Modified Asphalt Mixture[J]. Journal of Highway and Transportation Research and Development. 2023, 40(2):22-27,126.(in Chinese) [14] ZHENG Xin-yi, LIU Li-ping. Characterization of Hot Mix Asphalt Fumes during Mixing Linked with Mechanical Performances[J]. Journal of China&Foreign Highway, 2010, 30(1):254-258.(in Chinese) [15] CUI Pei-qiang. Research Methodologies on the Voc Emissions from Bituminous Materials and its Inhibitor[D]. Wuhan:Wuhan University of Technology, 2015.(in Chinese) [16] NIAN T F, LI P, WEI X Y, et al. The Effect of Freeze-Thaw Cycles on Durability Properties of SBS-Modified Bitumen[J]. Construction and Building Materials, 2018, 187(30):77-88. [17] ZHANG Hong-li. Experimental Study of Filter of Different Grades on Outdoor Airborne Particulate Matter[D]. Xi'an:Xi'an University of Architecture and Technology, 2018.(in Chinese) [18] LI Xiao-hong. Ultraviolet Spectrophotometry Determination of Bituminous Smoke[J]. Coal Technology, 2002(9):57-58.(in Chinese) [19] GERALD R, MARK S, DENNIS P, et al. Chemical and Mutagenic Properties of Asphalt Fume Condensates Generated under Laboratory and Field Conditions[J]. Mutation Research, 2000, 469(1):41-50. [20] XU T, HUANG X M. Study on Combustion Mechanism of Asphalt Binder by Using TG-FTIR Technique[J]. Fuel, 2010, 89(9):2185-2190. [21] YIN De-hong, ZHANG Xiong-fu, LU Jin-ming, et al. Petrochemical Technology[M]. Dalian:Dalian University of Technology Press, 2016.(in Chinese) [22] CAI Hong-mei. Research on the Effect of Asphalt Components to Environment in the Course of Using[J]. Qingdao:China University of Petroleum, 2010.(in Chinese) [23] LIU Han-bing, LÜ De-bao. Determination of the Asphalt Film Thickness of Asphalt Mixture[J]. Journal of Jilin University (Engineering and technology edition), 2011, 41(S2):153-158.(in Chinese) [24] LÜ De-bao, LIU Han-bing, GUAN Chang-lu. Study on Ascertaining Specific Surface Area of Asphalt Mixture Aggregate[J]. Journal of Highway and Transportation Research and Development, 2011, 28(5):28-32.(in Chinese) [25] XU T, WANG H C, HUANG X M, et al. Inhibitory Action Offlame Retardant on the Dynamic Evolution of Asphalt Pyrolysis Volatiles[J]. Fuel, 2013, 105:757-763.
2024, Vol. 18 
